6. Do not touch any key while the message "Load Status..." is displayed. This message indicates that the
program is running.
7. Check that the message "End Sum..." is displayed. This message indicates that the program has ended
normally.
8. Turn off the main power switch.
9. Remove the flash memory card.
10. Attach the interface cover.
11. Turn the main power switch on, and check the operation.
Test Pattern Print (SP5-902-001)
Executing Test Pattern Printing
1. Specify the pattern number and press the OK key.
2. Press the copy start key. The copy mode is activated (
3. Specify copy settings and press the
4. To return to the SP mode, press the
Test Patterns
key.
key.
Test Patterns Using VCU
Using SP Mode (Basic: D067/D072)
"Using SP and SSP Modes" in this section).
6
181