Using Sp Mode (Basic: D067/D072); Nvram Data Upload/Download (Sp5-824/825) - Ricoh D069 Field Service Manual

Using SP Mode (Basic: D067/D072)

NVRAM Data Upload/Download (SP5-824/825)

• Make sure that you turn off the main power switch before inserting or removing a flash memory card.
Data in the memory may be corrupted if you insert or remove the memory card with the main power
switch on.
This section illustrates how to copy the data from the BICU NVRAM to a memory card (
Upload/Download" writing onto open space on card) or from a memory card to the BICU NVRAM (
"NVRAM Data Upload/Download").
Overview
You can copy the data from the NVRAM to a flash memory card (NVRAM Upload) or from a flash memory
card to the NVRAM (NVRAM download).
SP5-824-1 (NVRAM Upload)
SP5-825-1 (NVRAM Download)
You should execute NVRAM Upload before replacing the NVRAM or before executing SP5-801-002
(Memory Clear > Engine). You can copy back the data from the flash memory card to the NVRAM as
necessary.
NVRAM Upload (SP5-824-001)
1. Turn off the main switch.
2. Remove the interface cover ( x 1).
3. Turn the face of the flash memory card to the rear of the copier, and insert it into the card slot 2.
4. Turn on the main power switch.
5. Activate the SP mode and select SP5-824-001.
6. The copier overwrites the data in the memory card with the data in the NVRAM. This takes about 20
seconds. If uploading fails, an error message appears. If an error message appears, retry the upload
procedure.
7. Turn off the main power switch.
8. Remove the memory card.
From the BICU to a flash memory card
From a flash memory card to the BICU
Using SP Mode (Basic: D067/D072)
"NVRAM Data
6
179