Ricoh D069 Field Service Manual page 85

2. If the surfaces of the tapes do not show "VOID", remove them from the corners of the box.
3. You can see the "VOID" marks [B] when you remove each seal. In this condition, they cannot be
attached to the box again.
Installation Procedure
• Unplug the main machine power cord before you do the following procedure.
• You must install the DataOverwriteSecurity unit in SD Card slot 1. However, the Postscript option and
others are also installed in SD Card slot 1. You must do the "SD Card Appli Move" procedure first if
you want to install the Data Overwrite Security unit.
1. Turn off the main power switch if the machine is turned on.
2. Disconnect the network cable if it is connected.
3. Turn the SD-card label face [A] to the rear of the machine. Then push it slowly into slot 1 until you
hear a click.
4. Connect the network cable if it needs to be connected.
5. Turn on the main power switch.
6. Input a machine serial number with SP 5811-001.
7. Go into the SP mode and push "EXECUTE" with SP5-878-001.
8. Exit the SP mode and turn off the operation switch. Then turn off the main power switch.
9. Turn on the machine power.
10. Go into the User Tools mode, and select System Settings> Administrator Tools> Auto Erase Memory
Setting> On.
11. Exit the User Tools mode.
Controller Options
2
83