Ricoh D069 Field Service Manual page 256

5. Appendix: SP Mode Tables
1103* Fusing Idling
Enables or disables the contact-release control. The following table lists the results.
1103 1
Fusing Temp Adj
1105*
Adjusts the target fusing temperature. Note that the thermistor is at the center of the hot
roller.
5
1105 1 Warm Up-Center
1105 3 Standby-Center
1105 5 Copying-Center
1105 7 Low Level 2-Center
1105 9 Thick-Center
1106 Display Fusing
1106 1 (Center) Displays the fusing temperature.
Fusing Soft Start DFU
Adjusts the number of zero-cross cycles of the fusing lamp AC supply needed to bring the
1107*
fusing lamp power to 100% while bringing the lamp up to the standby temperature or while
copying. Increase this value if the machine is experiencing sudden power dropouts.
1107 1 Warm Up Soft Start
1107 2 Other Soft Start
1107 3 Soft Stop Setting
1108* Set-Fusing Start
1108 1 Specifies the interval for fusing-temperature control.
64
Setting
C-R control
Idling time
Fusing quality
[0 = 10 times / 1 = 20 times / 2 = 50 times]
[0 = 10 times / 1 = 20 times / 2 = 50 times / 3 = 1 time]
[0: No / 1: Yes]
[0 = No / 1 = Yes]
0 = No
Works
Shorter
Lower
[140 to 180 / 160 / 1°C/step]
[140 to 160 / 150 / 1°C/step]
[140 to 180 / 160 / 1°C/step]
[0 to 80 / 60 / 1°C/step]
[140 to 185 / 165 / 1°C/step]
[0 = 1s / 1 = 1.5s / 2 = 2s]
1 = Yes
Does not work
Longer
Higher