Ncu Parameters - Ricoh D069 Field Service Manual

7. Appendix: Fax Service Program (Only For D068/D069)

NCU Parameters

• This section is used only for F/SPF models (D068/D069).
• The following tables give the RAM addresses and the parameter calculation units that the machine
uses for ringing signal detection and automatic dialing. The factory settings for each country are also
given. Most of these must be changed by RAM read/write (SP2-102), but some can be changed
using NCU Parameter programming (SP2-103); if SP2-103 can be used, this will be indicated in the
Remarks column. The RAM is programmed in hex code unless (BCD) is included in the Unit column.
7
288