15. For the North America model only:
Attach the FCC decal [A] at the right-hand side of the USB connector on the controller box
16. Reassemble the whole copier.
17. Attach the ferrite core [A] to the network cable and attach the cable to the copier if a network cable
is used.
• The ferrite core must be attached next to the network cable connector [B].
18. Attach the "Power Source: OFF" decal [C] to the under of main power switch at the left side of the
machine as shown above.
19. Plug in the power cord, and turn on the main switch.
20. For the North America model only: Perform the interface settings.
1) Start the SP mode.
Printer/Scanner Unit
2
71