Add/Edit Internet Connection - ZyXEL Communications EX3510-B1 User Manual

The following table describes the labels in this screen.
Table 16 Network Setting > Broadband
LABEL
Add New WAN
Interface
#
Name
Type
Mode
Encapsulation
802.1p
802.1q
IGMP Proxy
NAT
Default
Gateway
IPv6
MLD Proxy
Modify

6.2.1 Add/Edit Internet Connection

Click Add New WAN Interface in the Broadband screen or the Edit icon next to an existing WAN
interface to open the following screen. Use this screen to configure a WAN connection. The screen
varies depending on the mode, encapsulation, and IPv6/IPv4 mode you select.
Routing Mode
Use Routing mode if your ISP give you one IP address only and you want multiple computers to share an
Internet account.
The following example screen displays when you select the Routing mode and PPPoE encapsulation. The
screen varies when you select other encapsulation and IPv6/IPv4 mode.
Chapter 6 Broadband
DESCRIPTION
Click this button to create a new connection.
This is the index number of the entry.
This is the service name of the connection.
This shows it is an Ethernet connection.
This shows whether the connection is in routing or bridge mode.
This is the method of encapsulation used by this connection.
This indicates the 802.1p priority level assigned to traffic sent through this connection. This
displays N/A when there is no priority level assigned.
This indicates the VLAN ID number assigned to traffic sent through this connection. This displays
N/A when there is no VLAN ID number assigned.
This shows whether the Zyxel Device act as an IGMP proxy on this connection.
This shows whether NAT is activated or not for this connection.
This shows whether the Zyxel Device use the WAN interface of this connection as the system
default gateway.
This shows whether IPv6 is activated or not for this connection. IPv6 is not available when the
connection uses the bridging service.
This shows whether Multicast Listener Discovery (MLD) is activated or not for this connection. MLD
is not available when the connection uses the bridging service.
Click the Edit icon to configure the WAN connection.
Click the Delete icon to remove the WAN connection.
EX3510-B1 User's Guide
78