Regulator/Rectifier Removal/Installation; Charging Coil Line Check - KYMCO DINK 125 Service Manual

16
. BATTERY/CHARGING SYSTEM
DINK 50/125
Charging coil line
Measure the resistance between each Yellow
wire terminals.
Standard: 0.4－0.6 Ω (20ºC/68ºF)
Disconnect the regulator/rectifier connector.
Check for continuity between each Yellow
wire terminal regulator/rectifier side and
ground.
There should be no continuity.
REMOVAL/INSTALLATION
Remove the side body cover (refer to the
"FRAME COVERS
REMOVAL/INSTALLATION" section in
the chapter 2).
Disconnect the regulator/rectifier connectors
(1).
Remove the two bolts (2), regulator/rectifier
(3).
Installation is in the reverse order of removal.
16-12