12
. COOLING SYSTEM
THERMOSTAT
THERMOSTAT REMOVAL
REMOVAL
Drain the coolant (refer to the "COOLANT
REPLACEMENT" section in this
chapter).
Remove the luggage box (refer to the
"FRAME COVERS
REMOVAL/INSTALLATION" section in
the chapter 2).
Disconnect the water temperature sensor
connectors (1).
Disconnect the water hose (2) from the
thermostat housing.
Disconnect the air bleed hose (3) from the
thermostat housing.
Remove the mounting bolt (4) and the
thermostat housing from the cylinder head.
INSTALLATION
The installation sequence is the reverse of
removal.
*
Replace the O-ring with a new one and
apply grease to it.
After the water thermostat has been
installed, fill coolant and perform air
bleeding (refer to the "COOLANT
REPLACEMENT" section in this
chapter).
DINK50/ 125
12-20