Starter Motor Inspection; Starter Motor Removal - KYMCO DINK 125 Service Manual

Hide thumbs Also See for DINK 125:

Table of Contents

. STARTING SYSTEM

STARTER MOTOR

Disconnect the start motor cable ( 2) from the

start MAG (1).

Connect the start motor cable directly to the

battery positive terminal (3).

If the start motor does not turn, the starter

motor is faulty.

Remove the air cleaner (refer to the

"CARBURETOR" section in the chapter

Turn the ignition switch turned to "OFF"

Release the rubber cap (1) and remove the

terminal screw (2) to disconnect the start

motor cable from the start motor.

Remove the two mounting bolts (3) and

engine ground cable (4), then remove the start

Show Quick Links

Table of Contents

Troubleshooting