Oil Pump (Dink 125) Installation - KYMCO DINK 125 Service Manual

4
. LUBRICATION SYSTEM
INSTALLATION
Install the oil pump and oil separator and
tighten the two bolts.
＊
Make sure the pump shaft rotates freely
and arrow on the oil pump is upside.
Install the pump drive chain and driven gear,
then set the snap ring securely on the pump
shaft.
Install the oil separator cover properly.
＊
Fit the tab of the separator cover into the
slit in the separator.
4-5
Arrow Mark
Oil Separator
Pump Drive Chain
Pump Driven Gear
Oil Separator Cover
DINK 50/125
Bolts
Snap Ring
Bolt