Rear Fork Bearing Installation - KYMCO DINK 125 Service Manual

15
. REAR BRAKE/REAR FORK/REAR
WHEEL/REAR SHOCK ABSORBER
DINK50/125
Drive in a new bearing squarely until it is
fully seated, using the special tools.
Special tool:
Bearing installer A120E00014
Install the snap ring to the groove of the rear
fork securely.
Apply grease to the new dust seal lip and
install it to the rear fork.
Apply grease to the outer side collar and
install it to the rear fork.
Check the bushing (4) for wear or damage.
INSTALLATION
Apply grease to the final gear shaft.
15-24