KYMCO DINK 125 Service Manual page 156

7
. CYLINDER/PISTON
Apply engine oil to the cylinder wall, piston
and piston ring outer surfaces.
Pass the cam chain through the cylinder and
install the cylinder over the piston.
＊
Be careful not to damage the piston rings
and cylinder walls.
Install the two cylinder bolts/washers (1) and
after the cylinder head and camshaft holder
has installed (refer to the "CYLINDER
HEAD" section in the chapter 6), then tighten
the two cylinder bolts to specified torque.
Torque: 1 kgf-m (10 N-m, 7 lbf-ft)
Connect the water hose.
7-11
DINK 50/125