Ddns Settings - Interlogix TruVision NVR 10 User Manual

To configure PPPoE settings:
1. From the menu toolbar, click
2. Check the enable PPPoE box.
3. Enter your user name and password and confirm the password.
4. Click Apply and manually reboot the recorder to save the settings.

DDNS settings

DDNS servers allow you to connect to your recorder using a fixed address. This fixed
address needs to be registered with a DNS service. The DDNS setup menu allows you
to enable or disable DDNS and to configure it using ezDDNS, No-IP or DynDNS.
Note: Some service providers block the default RTSP streaming port 554 used for
video streaming, so if you are not receiving video images over the internet, you may
need to change it to another value. See Appendix C "Port forwarding information" on
page 137 for more information. See "Port forwarding information" in the appendix for
more information.
There are three ways to set up a DDNS account:
• ezDDNS: A free-of-charge service included with your recorder and fully managed
within the recorder interface
• DynDNS: A third-party service where users need to apply for a DynDNS account on
the Dyn.com website.
• No-IP: A third-party service where users need to apply for a no-IP account on the
no-ip.com website
Figure 23: ezDDNS setup window
TruVision NVR 10 User Manual
Network Settings
Chapter 11: Network settings
> PPPoE.
75