Interlogix TruVision NVR 10 User Manual page 73

2. Enter the required settings:
Option
1. NIC Type
2. Internal NIC IPv4
Address
3. Bridge PoE
Camera Network
4. Enable DHCP
5. IPv4 Address
6. IPv4 Subnet Mask Enter the subnet mask for your network so the recorder will be recognized
TruVision NVR 10 User Manual
Description
Network interface card (NIC) is a device used to connect the recorder to a
network. Select the NIC type used from the drop-down list.
Default value is 10/100M self-adaptive for the 4 channel recorder and
10/100/1000M self-adaptive for the 8 or 16 channel recorders.
Enter the internal NIC IPv4 address. This is the IP address of the
recorder's internal network managing only the PoE port cameras. This is
not the LAN IP address.
Default value is 192.168.254.1.
Check this box to enable the Bridge PoE Camera Network.
Default value is Enable.
DHCP (Dynamic Host Configuration Protocol) is a protocol for assigning
an IP address dynamically to a device each time it connects to a network.
Check this box if you have a DHCP server running and want your recorder
to automatically obtain an IP address and other network settings from that
server. The DHCP server is typically available in your router.
Default value is Disable.
Enter the IP address for the recorder. This is the LAN IP address of the
recorder.
Default value is 192.168.1.82.
within the network.
Default value is 255.255.255.0.
Chapter 11: Network settings
73