Interlogix TruVision NVR 10 User Manual page 25

Item
14. Focus + and -
15. Playback control
16. Search
17. Replay
18. Eject
19. Archive
Aim the remote control at the IR receiver located at the front of the unit to test
operation.
To change the address of the remote control to the recorder:
1. Press the Menu
Menu button. The default display menu window appears.
2. Click Device Management
3. Check the remote control ID value. The default value is 255. This device address is
valid for all IR controls.
Note: The recorder will respond to any remote control that has an address between
1 and 255.
4. On the remote control press the
5. Enter the device address value. It must be the same as that on the recorder.
6. Press the OK button on the remote control.
To place batteries into the IR remote control:
1. Remove the battery cover.
2. Insert the batteries. Make sure that the positive (+) and negative (−) poles are
correctly placed.
3. Replace the battery cover.
Troubleshooting the remote control
If the IR remote control is not functioning properly, perform the following tests:
• Check the battery polarity.
• Check the remaining charge in the batteries.
• Check that the IR remote control sensor is not masked.
If the problem still exists, please contact your administrator.
TruVision NVR 10 User Manual
Description
Use to control focus of camera lens.
Use to control playback (Rewind, Pause, Play, and Fast Forward).
Open the Search menu.
Replay the selected file from the beginning.
Eject the CD or DVD disk.
Press once to enter quick archive mode. Press twice to start archiving.
button on the front panel or right-click the mouse and select the
> General
Device
Settings.
button.
Chapter 4: Operating instructions
25