Configure Ptz Settings - Interlogix TruVision NVR 10 User Manual

5. Click Apply to save the settings and then click

Configure PTZ settings

Use the PTZ Setup
Ensure that the PTZ dome cameras are correctly connected to the RS-485 port on the
back panel.
Note: If a camera does not work correctly after configuring the recorder, check the
parameters entered.
To configure PTZ dome camera settings:
1. Click the PTZ Control
– Or –
From the menu toolbar, click
2. Select the camera, baud rate, data bit, stop bit, parity, flow control, PTZ protocol and
address for the camera. See Appendix E "Default menu settings" on page 134 for
the default values.
Note: It is important to ensure that the settings correspond with those used in the
PTZ camera.
3. Click Copy to copy the settings to another camera, if required, and select the
cameras.
4. Click Apply to save the settings and then click
TruVision NVR 10 User Manual
menu to configure IP cameras.
icon on the live view toolbar.
Camera Setup
Exit to return to live view.
> PTZ Setup.
Exit to return to live view.
Chapter 10: Camera setup
67