Interlogix TruVision NVR 10 User Manual page 56

Chapter 10: Camera setup
Figure 19: IP camera window
Table 11: Description of the IP camera window
Option
1. IP camera list
2. Sync Password
3. Manual Add
4. Device Search/Add
5. Upgrade
6. Delete
7. Refresh
To automatically add an IP camera:
1. From the menu toolbar, click
2. Click Device Search/Add
recorder LAN.
Note: To change an IP camera's IP address prior to adding it to a recorder, in the
device's search/add pop-up window, click 'Edit' and enter the required IP address as
well as the IP camera's credntials to chage it's IP address.
3. Check the boxes of the cameras that you want to add to the recorder.
4. Click Add to add the selected cameras to the list of devices in the recorder. Click
Done when complete in order to return to the main window.
56
Description
This shows the list of IP cameras added to the recorder. The camera
information shown is: Camera No., Status, PoE port, Edit, Advanced Set,
Live View, Camera Name, IP Camera Address, Manage Port, Protocol,
Device Model, Serial Number, and Firmware.
Change the cameras password or Sync with the "admin" password.
Add the selected cameras from the search results list to the recorder
system without modifying the camera configuration.
Search the network for available IP cameras. Add an IP camera to the
recorder system.
Upgrade IP camera software. Insert USB flash drive in the recorder and
select the upgrade file. The camera will automatically reboot once the
software is upgraded.
Delete the selected IP camera from the list.
Update the information displayed on a camera in the recorder device list.
Camera Setup
to search for any supported IP cameras located in the
> IP Camera Status.
TruVision NVR 10 User Manual