Live View Toolbar - Interlogix TruVision NVR 10 User Manual

Chapter 5: Live view
Sequencing cameras using the front panel:
Select the camera where you want to start sequencing. Press the
front panel to start sequencing. Press it again to stop sequencing.
Sequencing cameras using the mouse:
Select the camera where you want to start sequencing. Right-click the mouse and
select Start Sequence
Sequence to stop sequencing.

Live view toolbar

The live view toolbar in live view lets you quickly access regularly used commands.
Position the cursor over a video image and left- click the mouse. The toolbar appears
(see Figure 8 below).
Figure 8: Live view toolbar
Table 8: Description of the live view toolbar icons
Icon Description
Pause: Freeze the live image of the selected camera. Although the image pauses, time
and date information does not. The system clock continues to run.
Start Manual Recording: Start/stop manual recording.
The icon is red when manual recording is enabled. See "Recording schedule" on page
82 for information on setting up this function.
Instant Playback: Playback the recorded video from the last five minutes. If no
recording is found, then there was no recording made in the last five minutes.
Click the icon and select the desired camera. Click OK.
See "Modify the instant replay duration" on page 85 For more information.
Audio On: Enable/Disable audio output. The audio option must already have been
setup in the Display menu.
Snapshot: Capture a snapshot of a video image. The image is saved on the unit. See
"Search snapshots" on page 39 for more information.
PTZ Control: Enter PTZ control mode.
See "Configure PTZ settings" on page 66 for more information.
Digital Zoom: Enter digital zoom. See "Digital zoom" on page 33 for further information.
Image Settings: Enter the image settings menu to modify the image lighting levels.
There are two options:
32
to start the sequencing. Right-click again and select
Seq button on the
Stop
TruVision NVR 10 User Manual