Some Held Jobs Were Not Restored; Supply Needed To Complete Job - Lexmark MS810 Series User Manual

Troubleshooting

Some held jobs were not restored

Select Continue to clear the message. For non‑touch‑screen printer models, press
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
•
From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer models, press
to confirm.
•
Turn off the printer and then turn it back on.
• Update the network firmware in the printer or print server. For more information, visit the Lexmark support Web
site at http://support.lexmark.com.
Standard USB port disabled [56]
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press
to confirm.
Notes:
•
The printer discards any data received through the USB port.
•
Make sure the USB Buffer menu is not set to Disabled.

Supply needed to complete job

A supply needed to complete the job is missing. Cancel the current job.
Too many bins attached [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra bins.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Too many disks installed [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra printer hard disks.
to confirm.
297