Configuration Change, Some Held Jobs Were Not Restored [57]; Complex Page, Some Data May Not Have Printed [39]; Defective Flash Detected [51]; Disk Must Be Formatted For Use In This Device - Lexmark MX310 Service Manual

Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of any of the following possible changes in the printer:
•
The printer firmware has been updated.
•
The tray for the print job is removed.
•
The print job is sent from a flash drive that is no longer attached to the USB port.
•
The printer hard disk contains print jobs that were stored when the hard disk was installed in a different
printer model.
From the printer control panel, select Continue to clear the message. For non-touch-screen printer models,
press to confirm.

Complex page, some data may not have printed [39]

Try one or more of the following:
•
From the printer control panel, select Continue to ignore the message and continue printing. For
non‑touch‑screen printer models, press
•
Cancel the current print job. For non‑touch‑screen printer models, press
•
Install additional printer memory.
Defective flash detected [51]
Try one or more of the following:
•
Replace the defective flash memory card.
•
From the printer control panel, select Continue to ignore the message and continue printing. For
non‑touch‑screen printer models, press
•
Cancel the current print job.

Disk must be formatted for use in this device

From the printer control panel, select Format disk to format the printer hard disk and clear the message.
For non-touch-screen printer models, press
Note: Formatting deletes all the files stored in the printer hard disk.

Error reading USB drive. Remove USB.

An unsupported USB device is inserted. Remove the USB device, and then insert a supported one.

Error reading USB hub. Remove hub.

An unsupported USB hub has been inserted. Remove the USB hub, and then install a supported one.
to confirm.
to confirm.
to confirm.
Diagnostics and troubleshooting
127
7015
to confirm.