Cleaning Printer Parts - Lexmark MS810 Series User Manual

Maintaining the printer
3
Squeeze both sides of the empty staple case with your fingers, and then remove the staple case from the cartridge.
4
Insert the front side of the new staple case into the staple cartridge, and then push the rear side into the cartridge.
5
Push the staple cartridge into the finisher until it clicks into place.
6
Close the stapler door.

Cleaning printer parts

Cleaning the printer
Note: You may need to perform this task after every few months.
Warning—Potential Damage: Damage to the printer caused by improper handling is not covered by the printer
warranty.
1
Make sure that the printer is turned off and unplugged from the electrical outlet.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock when cleaning the exterior of the printer,
unplug the power cord from the electrical outlet and disconnect all cables from the printer before
proceeding.
2
Remove paper from the standard bin and multipurpose feeder.
3
Remove any dust, lint, and pieces of paper around the printer using a soft brush or vacuum.
1
1
2
1
255