Networking - Lexmark MS810 Series User Manual

Additional printer setup
In Windows 7 or earlier
a
Click , or click Start and then click Run.
b
Type control printers.
c
Press Enter, or click OK.
2
Select the printer you want to update, and then do either of the following:
•
For Windows 7 or later, select Printer properties.
•
For earlier versions, select Properties.
Navigate to the Configuration tab, and then select Update Now ‑ Ask Printer.
3
4
Apply the changes.
For Macintosh users
1
From System Preferences in the Apple menu, navigate to your printer, and then select Options & Supplies.
2
Navigate to the list of hardware options, and then add any installed options.
3
Apply the changes.

Networking

Notes:
•
Purchase a MarkNet N8350 wireless network adapter before setting up the printer on a wireless network. For
information on installing the wireless network adapter, see the instruction sheet that came with the adapter.
• A Service Set Identifier (SSID) is a name assigned to a wireless network. Wired Equivalent Privacy (WEP), Wi-Fi
Protected Access (WPA), WPA2, and 802.1X-RADIUS are types of security used on a network.
Preparing to set up the printer on an Ethernet network
To configure your printer to connect to an Ethernet network, organize the following information before you begin:
Note: If your network automatically assigns IP addresses to computers and printers, continue on to installing the
printer.
•
A valid, unique IP address for the printer to use on the network
•
The network gateway
•
The network mask
• A nickname for the printer (optional)
Note: A printer nickname can make it easier for you to identify your printer on the network. You can choose to
use the default printer nickname, or assign a name that is easier for you to remember.
You will need an Ethernet cable to connect the printer to the network and an available port where the printer can
physically connect to the network. Use a new network cable when possible to avoid potential problems caused by a
damaged cable.
35