Connecting The Printer To A Wireless Network Using The Embedded Web Server - Lexmark MS810 Series User Manual

Additional printer setup
Using the Push Button Configuration method
1
Depending on your printer model, navigate to either of the following:
•
> Settings >
> Wi‑Fi Protected Setup >
•
> Network/Ports > Network [x] > Network [x] Setup > Wireless > Wi‑Fi Protected Setup > Start Push
Button Method
•
> Network/Ports > Network [x] > Network [x] Setup > Wireless > Wi‑Fi Protected Setup > Start Push
Button Method
2
Follow the instructions on the printer display.
Using the Personal Identification Number (PIN) method
1
Depending on your printer model, navigate to either of the following:
• > Settings >
> Wi‑Fi Protected Setup >
• > Network/Ports > Network [x] > Network [x] Setup > Wireless > Wi‑Fi Protected Setup > Start PIN Method
•
> Network/Ports > Network [x] > Network [x] Setup > Wireless > Wi‑Fi Protected Setup > Start PIN Method
2
Copy the eight–digit WPS PIN.
3
Open a Web browser, and then type the IP address of your access point in the address field.
Notes:
•
The IP address appears as four sets of numbers separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
4
Access the WPS settings. For more information, see the documentation that came with your access point.
5
Enter the eight‑digit PIN, and then save the setting.

Connecting the printer to a wireless network using the Embedded Web Server

Before you begin, make sure that:
•
Your printer is connected temporarily to an Ethernet network.
• A wireless network adapter is installed in your printer and working properly. For more information, see the
instruction sheet that came with the wireless network adapter.
1
Open a Web browser, and then type the printer IP address in the address field.
Notes:
• View the printer IP address on the printer control panel. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2
Click Settings > Network/Ports > Wireless.
> Networks/Ports >
> Start Push Button Method
> Networks/Ports >
> Start PIN Method
> Network [x] > > Network [x] Setup >
> Network [x] > > Network [x] Setup >
38
> Wireless >
> Wireless >