Monogram 30" Owner's Manual page 34

Professional dual fuel ranges
Hide thumbs Also See for 30":
Table of Contents

Advertisement

Available languages

Available languages

Care and Cleaning
Professional
Dual
Fuel
Range
Dual-flame
stacked
burners
The burner consists of three ports: the burner
base, burner head and burner cap. The burner
head and burner cap can be lifted off, making
them easy to clean.
A CAUTION: Do NOT OPERATE
THE
BURNER WITHOUT ALL BURNER PARTS IN PLACE,
Surface burners should be cleaned routinely,
especially
after bad spillovers,
which could clog
the slots and holes in the burner heads.
The electrode
is located at the rear of each
burner.
Do not attempt
to disassemble
or clean
around any burner while another
burner is on. An
electric shock may result.
O
Burner Cap
Burner
Head
Burner Base
Electrode
To remove the burner
parts:
1. Turn all controls
OFF before removing
any
burner parts.
2. When cool, you may lift off the burner grates,
burner caps and burner heads for easier
cleaning,
Do not remove the burner
bases.
NOTE: The ZDP304 model has 2 different
size
burners. Be sure to replace the burners in the
same location.
Cleaning
Lift off burner parts only when cool, Wash in hot,
soapy water, You may use a plastic scouring
pad
to remove burned-on
food particles,
To remove
burned-on
food, soak the burner
heads in a solution
of mild liquid detergent
and
hot water for 20-30
minutes.
For more stubborn
stains, use a plastic scouring
pad or toothbrush.
If the spill goes inside the burner head assembly,
wash it under running water and shake to
remove excess water.
After Cleaning
Before replacing the burner parts, shake out
excess water and then dry them thoroughly.
To replace
the burner
parts:
Make sure that the burner parts are replaced in
the correct
location.
.
.
Replace the burner head on top of the burner
base, making sure that the hole in the burner
head is properly
aligned with the electrode
in the burner base. A small gap between the
base and head is normal.
Place the burner cap on top of the burner
head. Make sure that the burner cap is
properly
seated on the burner head.
Burner cap properly seated
J
Burner cap not properly seated
34

Advertisement

Table of Contents
loading

Table of Contents