Table of Contents
Advertisement
validate-reply
pattern pattern
sweep-min-
size
sweep-max-
size
sweep-interval
ointerface
Defaults
See parameters above.
Command
•
Modes
•
Command
Version 8.3.16.1
History
Usage
When you enter the ping command without specifying an IP address (Extended
Information
Ping), you are prompted for a target IP address, a repeat count, a datagram size (up
to 1500 bytes), a timeout (in seconds), and for Extended Commands. For
information on the ICMP message codes that return from a ping command, refer
to
Example (IPv4)
Dell#ping 172.31.1.255
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2
seconds:
Reply to request 1 from 172.31.1.208 0 ms
Reply to request 1 from 172.31.1.216 0 ms
Reply to request 1 from 172.31.1.205 16 ms
::
Control and Monitoring
(IPv4 only) Enter Y or N for reply validation.
•
N: Do not validate reply data.
•
Y: Do validate reply data.
Default is No.
(IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF.
Default: 0xABCD.
Enter the minimum size of datagram in sweep range. The
range is from 52 to 15359 bytes.
Enter the maximum size of datagram in sweep range. The
range is from 53 to 15359 bytes.
Enter the incremental value for sweep size. The range is from
1 to 15308 seconds.
(IPv4 only) Enter the outgoing interface for multicast packets.
Enter the IP address in A.B.C.D format.
•
For a Port Channel, enter the keywords port-channel
then a number. The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
EXEC
EXEC Privilege
Introduced on the MXL 10/40GbE Switch IO Module.
Internet Control Message Protocol (ICMP) Message
Types.
97
Advertisement
Table of Contents
