Dell MXL 10GbE Reference Manual page 233

Switch i/o module
Table of Contents

Advertisement

[byte]][log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this filter, you have two choices:
Parameters
source
mask
any
host ip-address
count
byte
log
threshold-in
msgs count
interval
minutes
monitor
Defaults
By default, 10 ACL logs are generated, if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Access Control Lists (ACL)
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no deny {any | host mac-address | mac-source-address
mac-source-address-mask}{any | host mac-address | mac-
destination-address mac-destination-address-mask}command.
command.
Enter the IP address in dotted decimal format of the network
from which the packet was sent.
(OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous (discontiguous).
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host and then enter the IP address to
specify a host IP address only.
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
(OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
(OPTIONAL) Enter the keyword interval followed by the
time period in minutes at which ACL logs must be generated.
The time interval range is from 1 to 10 minutes.
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
233

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mxl 40gbe

Table of Contents