Table of Contents
Advertisement
Parameters
any
host
mac-source-
address
mac-source-
address-mask
mac-
destination-
address
mac-
destination-
address-mask
ethertype
operator
count
byte
Defaults
Not configured.
Command
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Modes
Command
Version 8.3.16.1
History
Related
deny
Commands
seq
Access Control Lists (ACL)
Enter the keyword any to forward all packets.
Enter the keyword host then a MAC address to forward
packets with that host address.
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
(OPTIONAL) Specify which bits in the MAC address must
match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
Enter the destination MAC address and mask in
nn:nn:nn:nn:nn:nn format.
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
(OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
•
ev2 - is the Ethernet II frame format
•
llc - is the IEEE 802.3 frame format
•
snap - is the IEEE 802.3 SNAP frame format
(OPTIONAL) Enter the keyword count to count packets the
filter processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
Introduced on the MXL 10/40GbE Switch IO Module.
— configures a MAC ACL filter to drop packets.
— configure a MAC ACL filter with a specified sequence number.
193
Advertisement
Table of Contents
