Dell MXL 10GbE Reference Manual page 194

seq
Configure a filter with a specific sequence number.
Syntax
seq sequence-number {deny | permit} {any | host mac-address |
mac-source-address mac-source-address-mask} {any | host mac-
address | mac-destination-address mac-destination-address-mask}
[ethertype operator] [count [byte]]
Parameters
sequence-
number
deny
permit
any
host mac-
address
mac-source-
address
mac-source-
address-mask
mac-
destination-
address
mac-
destination-
address-mask
ethertype
operator
count
byte
194
Enter a number as the filter sequence number. The range is
from zero (0) to 65535.
Enter the keyword deny to drop any traffic matching this
filter.
Enter the keyword permit to forward any traffic matching
this filter.
Enter the keyword any to filter all packets.
Enter the keyword host and then enter a MAC address to
filter packets with that host address.
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
Specify which bits in the MAC address must be matched.
Enter the destination MAC address and mask in
nn:nn:nn:nn:nn:nn format.
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
(OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
• ev2 - is the Ethernet II frame format.
• llc - is the IEEE 802.3 frame format.
• snap - is the IEEE 802.3 SNAP frame format.
(OPTIONAL) Enter the keyword count to count packets the
filter processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
Access Control Lists (ACL)