Dell MXL 10GbE Reference Manual page 475

phy-firmware-
version
cpu data-plane
statistics
cpu party-bus
statistics
cpu private-
mgmt statistics
drops [unit 0-0
[port 1-56]]
stack-port 33–
56
unit 0–0
{counters |
details | port-
stats [detail] |
register}
Defaults none
Command
•
Modes
•
Command
Version 8.3.16.1
History
Example
Dell#show hardware stack-unit 0 phy-firmware-version
PortNumber
Debugging and Diagnostics
unit and port (1-56), and queue (0-14 or all), and
buffer-info. The buffer unit default is 1.
Each member of the stack is updated automatically with the
latest firmware while booting as well as during OIR. To dump
the physical firmware version for stack units, enter the
keywords phy-firmware-version.
(Optional) Enter the keywords cpu data-plane
statistics then the keywords stack port and its
number from 0 to 52 to display the data plane statistics,
which shows the High Gig (Higig) port raw input/output
counter statistics to which the stacking module is
connected.
Enter the keywords cpu party-bus statistics, to
display the Management plane input/output counter
statistics of the pseudo party bus interface.
Enter the keywords cpu private-mgmt statistics, to
display the Management plane input/output counter
statistics of the Private Management interface.
Enter the keyword drops to display internal drops on the
selected stack member. Optionally, use the keyword unit
with 0 to select port-pipe 0, and then use port 1-56 to
select a port on that port-pipe.
Enter the keywords stack-port and a stacking port number
to select a stacking port for which to display statistics.
Identify the stack port number as you would to identify a 10G
port that was in the same place in one of the rear modules.
Enter the keyword unit then 0 for port-pipe 0, and then
enter one of the following keywords to troubleshoot errors
on the selected port-pipe and to give status on why a port is
not coming up to register level: counters, details, port-
stats [detail], or register.
EXEC
EXEC Privilege
Introduced on the MXL 10/40GbE Switch IO Module.
Status
NOTE: You can identify stack port numbers by physical
inspection of the rear modules. The numbering is the
same as for the 10G ports. You can also inspect the
output of the show system stack-ports command.
Programmed Version SW Version
475