Dell MXL 10GbE Reference Manual page 572

Key
l
a
T
t
q
Example (Single
systest-3 Monitor time: 00:00:06 Refresh Intvl.: 2s Time:
Interface)
03:26:26
Interface: Gi 0/3, Enabled, Link is Up, Linespeed is 1000 Mbit
Traffic statistics:
Over 127B packets:
Over 255B packets:
Over 511B packets:
Over 1023B packets:
Input IP checksum:
mtu
Set the link maximum transmission unit (MTU) (frame size) for an Ethernet interface.
Syntax
mtu value
To return to the default MTU value, use the no mtu command.
Parameters
value
572
Description
Change the view to the next interface on the line card, or if
in line card mode, the next line card in the chassis.
Change the view to the previous interface on the line card,
or if in line card mode, the previous line card in the chassis.
Increase the screen refresh rate.
Decrease the screen refresh rate.
Return to the CLI prompt.
Input bytes:
Output bytes:
Input packets:
Output packets:
64B packets:
Over 64B packets:
Error statistics:
Input underruns:
Input giants:
Input throttles:
Input CRC:
Input overrun:
Output underruns:
Output throttles:
m - Change mode
l - Page up
T - Increase refresh interval
q - Quit
Enter a maximum frame size in bytes. The range is from 594
to 9252. MXL Switch Range is from 594 to 12000. The
default is 1554.
Current Rate
9069828 43 Bps
606915800 43 Bps
54001 0 pps
9401589 0 pps
67 0 pps
49166 0 pps
350 0 pps
1351 0 pps
286 0 pps
2781 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
c - Clear screen
a - Page down
t - Decrease refresh interval
Delta
86
86
1
1
0
1
0
0
0
0
0
0
0
0
0
0
0
0
Interfaces