Table of Contents
Advertisement
2.
Enter the protocol spanning-tree pvst command. The prompt changes to include (conf-
pvst).
You can return to CONFIGURATION mode by using the exit command.
PREFIX-LIST Mode
To configure a prefix list, use PREFIX-LIST mode.
To enter PREFIX-LIST mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the ip prefix-list command. Include a name for the prefix list. The prompt changes to
include (conf-nprefixl).
You can return to CONFIGURATION mode by using the exit command.
PROTOCOL GVRP Mode
To enable and configure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For
more information, refer to
To enter PROTOCOL GVRP mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the protocol gvrp command. The prompt changes to include (config-gvrp).
You can return to CONFIGURATION mode by using the exit command.
RAPID SPANNING TREE (RSTP) Mode
To enable and configure RSTP, use RSTP mode. For more information, refer to
Protocol
(RSTP).
To enter RSTP mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the protocol spanning-tree rstp command. The prompt changes to include (conf-
rstp).
You can return to CONFIGURATION mode by using the exit command.
ROUTE-MAP Mode
To configure a route map, use ROUTE-MAP mode.
To enter ROUTE-MAP mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Use the route-map map-name [permit | deny] [sequence-number] command. The prompt
changes to include (config-route-map).
You can return to CONFIGURATION mode by using the exit command.
ROUTER OSPF Mode
To configure OSPF, use ROUTER OSPF mode. For more information, refer to
(OSPF).
CLI Basics
GARP VLAN Registration
(GVRP).
Rapid Spanning Tree
Open Shortest Path First
57
Advertisement
Table of Contents
