Table of Contents
Advertisement
one port and forwards (mirrors) them to another port. The source port is the
monitored port (MD) and the destination port is the monitoring port (MG).
Related
deny
Commands
seq
seq
To a deny or permit filter in a MAC access list while creating the filter, assign a sequence number.
Syntax
seq sequence-number {deny | permit} {any | mac-source-address
[mac-source-address-mask]} [count [byte]] [log [interval
minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, use the no seq sequence-number command.
Parameters
sequence-
number
deny
permit
any
mac-source-
address
mac-source-
address-mask
count
byte
log
threshold-in
msgs count
188
— configures a MAC ACL filter to drop packets.
—configure a MAC ACL filter with a specified sequence number.
Enter a number from 0 to 65535.
Enter the keyword deny to configure a filter to drop packets
meeting this condition.
Enter the keyword permit to configure a filter to forward
packets meeting this criteria.
Enter the keyword any to filter all packets.
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
(OPTIONAL) Specify which bits in the MAC address must
match. If no mask is specified, a mask of 00:00:00:00:00:00
is applied (in other words, the filter allows only MAC
addresses that match).
(OPTIONAL) Enter the keyword count to count packets the
filter processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
(OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
Access Control Lists (ACL)
Advertisement
Table of Contents
