Dell MXL 10GbE Reference Manual page 258

destination-
mac-address
mac-address-
mask
any
vlan vlan-id
ip-address
opcode code-
number
count
byte
order
log
interval
minutes
threshold-in
msgs count
monitor
258
Enter a MAC address and mask in the nn:nn:nn:nn:nn format.
For the MAC address mask, specify which bits in the MAC
address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
Enter the keyword any to match and drop any ARP traffic on
the interface.
Enter the keyword vlan followed by the VLAN ID to filter
traffic associated with a specific VLAN. The range is 1 to
4094 and 1 to 2094 for ExaScale (you can use IDs 1 to 4094).
To filter all VLAN traffic specify VLAN 1.
Enter an IP address in dotted decimal format (A.B.C.D) as the
target IP address of the ARP.
Enter the keyword opcode and then enter the number of the
ARP opcode. The range is 1 to 16.
(OPTIONAL) Enter the keyword count to count packets the
filter processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
(OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
(OPTIONAL) Enter the keyword interval followed by the
time period in minutes at which ACL logs must be generated.
The interval range is from 1 to 10 minutes.
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
Access Control Lists (ACL)