Dell MXL 10GbE Reference Manual page 243

Parameters
source
mask
any
host ip-address
destination
dscp
message-type
count
byte
order
fragments
log
threshold-in
msgs count
interval
minutes
monitor
Access Control Lists (ACL)
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or noncontiguous.
Enter the keyword any to match and drop specific Ethernet
traffic on the interface.
Enter the keyword host and then enter the IP address to
specify a host IP address.
Enter the IP address of the network or host to which the
packets are sent.
Enter the keyword dscp to deny a packet based on the
DSCP value. The range is 0 to 63.
(OPTIONAL) Enter an ICMP message type, either with the
type (and code, if necessary) numbers or with the name of
the message type. The range is 0 to 255 for ICMP type and 0
to 255 for ICMP code.
(OPTIONAL) Enter the keyword count to count packets the
filter processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
Enter the keyword fragments to use ACLs to control packet
fragments.
(OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
(OPTIONAL) Enter the keyword interval followed by the
time period in minutes at which ACL logs must be generated.
The interval range is from 1 to 10 minutes.
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
243