Table of Contents
Advertisement
To enter IP ACCESS LIST mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Use the ip access-list standard or ip access-list extended command. Include a name
for the ACL. The prompt changes to include (conf-std-nacl) or (conf-ext-nacl).
You can return to CONFIGURATION mode by using the exit command.
LINE Mode
To configure the console or virtual terminal parameters, use LINE mode.
To enter LINE mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the line command. Include the keywords console or vty and their line number available on
the switch. The prompt changes to include (config-line-console) or (config-line-vty).
You can exit this mode by using the exit command.
MAC ACCESS LIST Mode
To enter MAC ACCESS LIST mode and configure either standard or extended access control lists (ACLs),
use the mac access-list standard or mac access-list extended command.
To enter MAC ACCESS LIST mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Use the mac access-list standard or mac access-list extended command. Include a
name for the ACL. The prompt changes to include (conf-std-macl) or (conf-ext-macl).
You can return to CONFIGURATION mode by using the exit command.
MULTIPLE SPANNING TREE Mode
To enable and configure the multiple spanning tree protocol (MSTP), use MULTIPLE SPANNING TREE
mode , as described in
To enter MULTIPLE SPANNING TREE mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the protocol spanning-tree mstp command.
You can return to CONFIGURATION mode by using the exit command.
Per-VLAN SPANNING TREE (PVST+) Plus Mode
To enable and configure the Per-VLAN Spanning Tree (PVST+) protocol, use PVST+ mode. For more
information, refer to
Per-VLAN Spanning Tree Plus
NOTE: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.
To enter PVST+ mode:
1.
Verify that you are logged in to CONFIGURATION mode.
56
Multiple Spanning Tree Protocol
(MSTP).
(PVST+).
CLI Basics
Advertisement
Table of Contents
