Dell MXL 10GbE Reference Manual page 256

Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Command CONFIGURATION-IP ACCESS-LIST-EXTENDED
Modes
Command
Version 9.4(0.0)
History
Version 9.3(0.0)
Version 8.3.16.1
Usage
The order option is relevant in the context of the Policy QoS feature only. For
Information
more information, refer to the "Quality of Service" chapter of the Dell Networking
OS Configuration Guide.
The MXL 10/40GbE System IO Module cannot count both packets and bytes, so
when you enter the count byte options, only bytes are incremented.
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP
port operators (for example, gt, lt, or range) may require more than one entry. The
range of ports is configured in the CAM based on bit mask boundaries; the space
required depends on exactly what ports are included in the range.
When the configured maximum threshold is exceeded, generation of logs is
stopped. When the interval at which ACL logs are configured to be recorded
expires, the subsequent, fresh interval timer is started and the packet count for that
new interval commences from zero. If ACL logging was stopped previously
because the configured threshold is exceeded, it is re-enabled for this new interval.
If ACL logging is stopped because the configured threshold is exceeded, it is re-
enabled after the logging interval period elapses. ACL logging is supported for
standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You can configure
ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable
logging for ACLs that are associated with egress interfaces.
You can activate flow-based monitoring for a monitoring session by entering the
flow-based enable command in the Monitor Session mode. When you enable
this capability, traffic with particular flows that are traversing through the ingress
and egress interfaces are examined and, appropriate ACLs can be applied in both
the ingress and egress direction. Flow-based monitoring conserves bandwidth by
monitoring only specified traffic instead all traffic on the interface. This feature is
particularly useful when looking for malicious traffic. It is available for Layer 2 and
Layer 3 ingress and egress traffic. You may specify traffic using standard or
extended access-lists. This mechanism copies all incoming or outgoing packets on
one port and forwards (mirrors) them to another port. The source port is the
monitored port (MD) and the destination port is the monitoring port (MG).
256
Added support for flow-based monitoring on the MXL
10/40GbE Switch IO Module platform.
Added support for logging of ACLs on the MXL 10/40GbE
Switch IO Module platform.
Introduced on the MXL 10/40GbE Switch IO Module
platform.
Access Control Lists (ACL)