Method Of Setting And Changing Function Parameter Data In Custom Mode - Panasonic VF100 Instruction Manual

10-2. Method of setting and changing function parameter data in custom mode

Used to set, change and confirm function parameter data distributed to custom parameter No.
In respect of changeable function parameters during operation, refer to "changeable during operation
" item in "9-2 Function parameters table".
(See page 57)
! When changing the data during operation, the inverter may starts or stops suddenly
Caution
if the motor and motor load changes greatly.
(Ensure personal safety before using this function.)
Failure to do so could lead to injury.
[Setting example] Change "P002" (1
"U001" from "5.0" to "10.0"
Stop state or operation state (at 50.0Hz)
MODE
Press the MODE button.
MODE
Press the MODE button.
Press the MODE button.
MODE
MODE
Press the MODE button and select the "custom mode".
Press the SET button and confirm the current function
parameter No. to be distributed.
* When function parameter No. in the custom mode
SET is displayed, a dot following "P" is displayed.
"P" changes to "P.".
(If a password is set, it's necessary to input the password.
Refer to page 139.)
Press the SET button to display parameter P008 data.
SET
(Main display will flicker.)
Press the UP button to set the displayed value to "10.0"
(Main display will flicker.)
[Continued to next page]
st
deceleration time) data distributed to custom parameter
.
.
143