P120: 2Nd Change Point Frequency 1; P121: 2Nd Change Point Voltage 1; P122: 2Nd Change Point Frequency 2; P123: 2Nd Change Point Voltage 2 - Panasonic VF100 Instruction Manual

nd
P120£º2 change point frequency 1
nd
P121£º2 change point voltage 1
nd
P122£º2 change point frequency 2
nd
P123£º2 change point voltage 2
Used to set change points 1 and 2 set with 3C mode in "P005: V/F mode".
(These parameters are valid only when parameter P005 is set to "3C".)
[Parameter P120: 2 nd
Data setting range (Hz)
[Parameter P121: 2
Data setting range (%)
[Parameter P122: 2 nd
Data setting range (Hz)
[Parameter P123: 2
Data setting range (%)
Note
•ERead carefully details on "P005: V/F mode" before setting.
nd
•EIf 2 change point frequencies 1 and 2 are set to be higher than base frequency, 2
point frequencies 1 and 2 will operate according to setting value of base frequency.
•EIf 2 nd change point frequency 2 is set to be lower than 2
point frequency 2 will operate according to setting value of 2nd change point frequency 1.
•EWhen setting "P117: Torque boost level 2", if 2
than torque boost level 2, 2
value of torque boost level 2.
•EIf 2 nd change point voltage 2 is set to be lower than 2
voltage 2 will operate according to setting value of 2
122
change point frequency 1]
0.5 to 400.0
nd change point voltage 1]
0 to 100
change point frequency 2]
0.5 to 400.0
nd
change point voltage 2]
0 to 100
nd
change point voltage1 and 2 will operate according to setting
Max. output frequency (P008)
Base frequency 2 (P116)
100
Output
nd
2 change point frequency 2
voltage
(P122)
(%)
2 nd change point
frequency 1
(P120)
0
nd change point frequency 1, 2
nd change point voltage 1 and 2 is set to be lower
nd change point voltage 1, 2
nd change point voltage 1.
Ïà¹Ø P005, P008, P036
Related
P116, P117
²ÎÊý
parameters
2 nd change point
voltage 2 (P123)
nd
2 change point
voltage 1 (P121)
Output frequency (Hz)
nd
change
nd change
nd change point
¡«
P040