P135: Communication Protocol Select; P136: Communication Station No. Setting; P137: Communication Speed Setting; P138 - P142 - Panasonic VF100 Instruction Manual

P135£ºCommunication protocol select
P136£ºCommunication station No. setting
P137£ºCommunication speed setting
P138£ºStop bit length
Used to set the parameters necessary for communication when sending command to the inverter.

[P135: Communication protocol select]

For VF100, two protocols MEWTOCOL-COM and MOD-BUS (RTU) are available. Either protocol
can be set for using.

[P136: Communication station No. setting]

Data setting range

[P137: Communication speed setting]

Data setting value
48
96
192
384
[P138: Stop bit length]
Data setting value
1
2
Note
•E In respect of each protocol, read descriptions of "12. Supplementary explanation of communication
function" (page 154) carefully.
•E The power supply is turned off once after setting the data for the communication parameters
P135 to P142.
The data setting value will be displayed in the inverter after the power supply is turned on again.
134
Data setting value
0
1
1 to 31
Details of function
4800 bps
9600 bps
19200 bps
38400 bps
Details of function
1 bit
2 bit
P139£ºParity check
P140£ºTimeover detect
P141£ºSend wait time
P142£ºTEXT completion judgment time
Details of function
MEWTOCOL-COM
MOD-BUS(RTU)
[P139: Parity check]
Data setting value
0
1
2
[P140: Timeover detect]
Data setting range (sec)
* "0000" is setting not to perform the time-over detect.
[P141: Send wait time]
Data setting range (msec)
[P142: TEXT completion judgment time]
Data setting range (msec)
* The function is valid only protocol MOD-BUS (RTU)
is used.
Details of function
No parity check
Odd
Even
0000•E0.1 to 60.0
1 to 1000
3 to 200