If Not Connected To A Network; Checking The Connection To The Network; Overview; Using The Ping Function - Canon iR3570 Service Manual

Chapter 2
machine to the 2-level cassette pedestal Y2 or more.)
- Shut-Down Warning Label
1) Attach the Shut-Down warning label [1] of the appropriate language to the
right cover (rear) of the machine (i.e.,. on the left inside [2] of the main
power supply.).
- Toner Bottle Warning Label
1) Open the front cover [1].
2) Attach the Toner Bottle warning label [1] of the appropriate language
behind [2] the front cover.
[1]
- Ferrite Core (230V model only)
1) Fit the ferrite core [1] to the network cable [2].
Be sure to fit the ferrite core as follows to protect against noise:
- Be sure to fit it as close to the joint between the machine and the network
cable as possible.
2-16
F-2-71
[2]
[1]
F-2-72
F-2-73
[2]
F-2-74
- The harness must be wound around the ferrite core once before the core is
fixed in place.
- The harness is not trapped by the ferrite core.
When installing the machine newly or when replacing the harness, be
sure not to leave behind the ferrite core.

2.2.13 If Not Connected to a Network

iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / iR3530 /
Reference
If the machine is not connected to a network, its control panel will indicate
the message "Check the Connection to the Network." To disable the mes-
sage, turn off the following user mode item:
system setup>network>Ethernet driver setup>auto detect

2.3 Checking the Connection to the Network

2.3.1 Overview

iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / iR3530 /
The instructions that follow apply only when the machine is connected to a
network.
If the user's network environment is based on TCP/IP, use the PING function
to make sure that the network settings are correct.
If the user's network environment is based on IPX/SPX or AppleTalk, on the
other hand, such a check need not be made.

2.3.2 Using the PING Function

iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / iR3530 /
1) Make the following
COPIER>TEST>NETWORK>PING.
2) Enter the correct IP address using the control panel keypad, and press the
OK key.
3) Press the Start key.
- If successful, the indication will be 'OK'. If the attempt fails, however, 'NG'
will be indicated.
<NETWORK> < 1/1 > <READY >
PING 0. 0. 0. 0
[2]
[1]
+/-
F-2-76
[1] Result (OK/NG)
[2] IP address input

2.3.3 Making a Check Using a Remote Host Address

iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / iR3530 /
You can use a remote host address in combination with the PING function to
check the connection to the network.
[1]
[2]
F-2-75
selections in service
OK
0007-6496
0007-5605
0007-5600
mode:
0007-5603