Attaching Other Parts - Canon iR3570 Service Manual

2) Attach the Toner Bottle warning label [1] of the appropriate language
behind [2] the front cover.
[1]
- Ferrite Core (230V model only)
1) Fit the ferrite core [1] to the network cable [2].
Be sure to fit the ferrite core as follows to protect against noise:
- Be sure to fit it as close to the joint between the machine and the network
cable as possible.
- The harness must be wound around the ferrite core once before the core is
fixed in place.
- The harness is not trapped by the ferrite core.
When installing the machine newly or when replacing the harness, be
sure not to leave behind the ferrite core.
- Reversing Guide (iR3570/4570 model only)
1) Fit the reversing guide [1].
F-2-65
[2]
F-2-66
[1]
[2]
F-2-67
- Touch pen holder/touch pen
1) Peel off the backing paper, and attach the touch pen holder [1] to the
control panel.
2) Put the touch pen [2] in the touch pen holder.
[2]
[1]

2.2.12 Attaching Other Parts

iR2230 / / iR3530 /
- Service Book Holder
1) Remove release paper of the double-sided tape on the rib of the service
book folder [1], and attach the holder to the bottom plate of the pedestal.
Locations where the service book folder cannot be attached.
- Inside the machine (Inner side of the front cover)
- Locations where the louver is blocked.
- Locations where the grips are blocked.
Memo:
Attach the service book holder to the left cover of the machine if the pedestal
is not installed.
- Lower right cover
1) Attach the lower right cover [1]. (Perform this step when attaching the
Chapter 2
F-2-68
F-2-69
F-2-70
0010-2915
2-15