Canon iR3570 Service Manual page 400

Chapter 9
1) Remove the screw [1] and the stepped screw [2], and detach the inside
delivery cover unit [3].
Note 1
Point to note when removing the inside delivery cover unit
Remove the inside delivery cover unit while supporting the guide [1] in the
arrow direction A and opening it in the arrow direction B in the figure. Oth-
erwise, the guide may come off the inside delivery cover unit.
Note 2
Procedure for attaching the guide
Perform the following steps if the guide has come off the inside delivery cov-
er unit.
1) Attach the torsion spring [2] to the duplexing support feeder mount [1]. At
this time, hook the edge of the torsion spring on the area A of the
duplexing support feeder mount.
9-8
[1]
F-9-22
F-9-23
F-9-24
[A]
[2]
2) Attach the guide [1] to the duplexing support feeder mount [2]. At this
time, fit [b] into [a] and [d] into [c]. Make sure that the edge [e] of the
torsion spring is outside the guide.
[1]
[1]
[1]
3) Hook the edge [1] of the torsion spring on the spring-hook area [2] of the
inside delivery cover.
[1]
F-9-25
[d] [2]
[c]
[e]
[2]
[2]
[a]
[b]
F-9-26