Removing The Toner Feedscrew Motor; Static Charge Eliminator; Removing The Static Eliminator - Canon iR3570 Service Manual

Chapter 7
2) Disconnect the 3 connectors [1] found at the front and the connector [2]
found at the rear.
3) Open the 11 wire saddles [1], and pull out the harness [3] through the hole
[2] in the plate.
4) Remove the 3 screws [1], and detach the hopper assembly [2].
When fitting the hopper assembly to the machine, be sure that the connectors
[1] are securely connected. If the connectors [1] are not connected, the envi-
ronment heater will not be supplied with power, leading to image faults.
7-42
F-7-233
F-7-234
F-7-235
F-7-236

7.12.10.12 Removing the Toner Feedscrew Motor

iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / / iR3530 /
1) Disconnect the connector [1].
2) Remove the screw [1], and detach the toner feedscrew motor assembly [2].
3) Remove the screw [1], and detach the toner feedscrew motor [3] from the
base.

7.12.11 Static Charge Eliminator

7.12.11.1 Removing the Static Eliminator

iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N /
/ iR4570N / iR2230 / / / iR3530 /
1) Open the right door [1].
F-7-237
F-7-238
F-7-239
F-7-240
0007-8385
0007-8428