Canon iR3570 Service Manual page 659

Sub-item
FTPTXPN Specifying the send destination port (FTP) number
<Setting range>
0 to 65535 (Default: 21)
DFDST-L1 Adjusting the dust detection level when DF is used (Inter-paper correction)
Setting a greater value makes it easy to detect even small particles.
<Setting range>
0 to 255
(0 to set this mode OFF) (Default: 242)
DFDST-L2 Adjusting the dust detection level when DF is used (Post-job detection)
Setting a greater value makes it easy to detect even small particles.
<Setting range>
0 to 255
(0 to set this mode OFF) (Default: 242)
CCD-LUT Setting whether or not to use LUT for gain correction
0: Do not use (Default)
1: Use (One-point correction)
2: Do not use (Three-point correction)
ENVP-INT Setting the in-machine temperature & humidity and fixing temperature log
acquisition cycle
Select COPIER>FUNCTION>MISC-P>ENV-PRT and
COPIER>DISPLAY>ENVRNT to set the log acquisition cycles.
<Setting range>
0 to 480 <minute> (0 for no log acquisition)
Default: 60
BASE-SW Switching from the MEAP-Full mode to the Base model
<Setting range>
0: OFF (Base model), 1: ON (Full model)
FIX-LOW Improving fixing at low temperature
Note: Valid for iR3570/3570F/4570/4570F only
<Setting range>
0: OFF [Default], 1: Low-temperature fixing improvement mode ON
SC-L-CNT Switching the threshold value of the paper size (Large/Small) of the scan counter
<Setting range>
0: Count B4 as the small size [Default]
1: Count B4 as the large size
FIX-CLN Setting the timing at which the fixing pressure roller is cleaned
<Setting range>
0: No cleaning(Default), 1: Once every 500 sheets at 225deg C regulated
temperature and 60-second idling, 2: Once every 200 sheets at 225deg C regulated
temperature and 60-second idling, 3: Once every 100 sheets at 225deg C regulated
temperature and 60-second idling
CPMKP- Turning ON and OFF the sequence of reducing the copy speed to maintain the fixing
SW performance for copy images
<Setting range>
0: OFF, 1: ON
HUM-SW switches over charging output settings based on humidity sensor readings
range of settings: between 0 and 5
Using the Mode Item
Select a setting between 1 and 5 to suit the site environment so that the transfer
current output will be controlled accordingly.
low-humidity environment: increases the transfer current output
high-humidity environment: decreases the transfer current output
1: low humidity
2: relatively low humidity
3: normal humidity
4: relatively high humidity
5: high humidity
0: automatic control based on humidity sensor reading (default)
SCANSLCT Turning ON or OFF the function of calculating a scan area from the selected paper
size
<Setting range>
0: OFF (Determining the scan area by document detection)
1: ON (Determining the scan area by paper size)
SENS-CNF Setting the arrangement of document detection sensors
<Setting range>
0: AB type [Default]
1: Inch type
2: A type
RAW- Setting whether or not to print out received data with no change
DATA If a received image has a problem, the problem is used to isolate the data contents
and image processing.
<Setting range>
0: Usual operation [Default]
1: Print out with no change
COPIER > OPTION > BODY
Description
Chapter 16
Level
1
1
1
1
1
1
1
1
2
2
2
2
2
2
16-33