5-8
ENGINE REMOVAL AND INSTALLATION
• Install the clip D, washer E and cotter pin F.
Replace the cotter pin F with a new one.
• Install the kick starter lever in the correct position. (!8-7)
$ Kick starter lever bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Fit the projection of the carburetor to the depression of intake
pipe.
• Temporarily tighten the muffler mounting front bolt F and rear
bolt G temporarily.
• Install the muffler gasket H and exhaust pipe gasket I.
Use new gaskets to prevent exhaust gas leakage.
• Insert the exhaust pipe to muffler and cylinder head.
• Temporarily tighten the exhaust pipe nuts J.
CAUTION
CAUTION