13-8
COOLING SYSTEM
• Remove the shim 3 and water pump shaft 4.
• Remove the oil seal.
Replace the removed oil seal with a new one.
NOTE:
If there is no abnormal condition, the oil seal removal is not nec-
essary.
INSPECTION
IMPELLER AND WATER PUMP SHAFT
• Inspect the impeller and water pump shaft for damage.
• Replace the defective parts with a new one if necessary.
OIL SEAL
• Visually inspect the oil seal for damage.
• If any defects are found, replace the oil seal with a new one.
INSTALLATION
Install the water pump in the reverse order of removal. Pay
attention to the following points:
OIL SEAL
• Apply THREAD LOCK SUPER to the outer surface of the oil
seal.
% 99000-32110: THREAD LOCK SUPER "1322"
CAUTION
or equivalent