Inspection; Dust Seal And Bearing Replacement - Suzuki RM-Z450 Owner's Service Manual

INSPECTION

WHEEL SPACER AND DUST SEAL
• Inspect the rear wheel spacers 1 and dust seals 2 for wear
and cracks.
• If any defects are found, replace the spacer together with the
dust seal.
NOTE:
Apply grease on the spacer and dust seal before reassembling.
SPROCKET
• Inspect the sprocket teeth for wear.
• If they are worn as shown, replace the two sprockets and
drive chain as a set.
AXLE SHAFT ('15-3)
WHEEL RIM ('15-4)
WHEEL BEARING ('15-4)

DUST SEAL AND BEARING REPLACEMENT

• Remove the snap ring 1.
" 09900-06108: Snap ring pliers
FRONT AND REAR WHEELS
Normal wear
Excessive wear
15-9