Inspection; Installation - Suzuki RM-Z450 Owner's Service Manual

7-10 CLUTCH

INSPECTION

• Inspect the clutch sleeve hub and primary driven gear for
wear and cracks.
• If necessary, replace the sleeve hub or driven gear.
• Inspect the needle bearings and spacer for damage and
wear.
• If any defects are found, replace the bearing or spacer.

INSTALLATION

Install the primary driven gear and clutch sleeve hub in the
reverse order of removal. Pay attention to the following points:
• Apply engine oil to the spacer 1 and needle bearings 2.
• Install the spacer 1 and needle bearings 2.
• Install the primary driven gear 3.
• Install the washer 4.
• Fit the clutch sleeve hub 5, new lock washer 6 and clutch
sleeve hub nut 7.
NOTE:
The concave side of clutch sleeve hub nut faces inside.