Suzuki RM-Z450 Owner's Service Manual page 184

OIL PUMP No.2
Install the oil pump No.2 in the reverse order of removal. Pay
attention to the following points:
• Install the pin 2 to oil pump No.2 shaft 1.
• Install the inner rotor 3 to oil pump No.2 shaft 1.
NOTE:
Fit the slot A of the inner rotor to the pin 2.
• Apply engine oil to the oil pump shaft, outer rotor and Inner
rotor.
• Install the oil pump No.2 shaft 2 and inner rotor 3 to crank-
case.
• Install the outer rotor 4 to crankcase.
Face the punch mark B on outer rotor 4 to the crank-
case.
• Install the oil pump No.2 cover 5.
• Install the magneto cover. (!14-12)
• Install the gearshift lever. (!9-7)
INSPECTION AFTER INSTALLATION
• Engine oil level and oil leakage (!2-11)
• Engine coolant level and coolant leakage (!2-14, -15)
• Oil pressure (!2-37)
CAUTION
LUBRICATION SYSTEM 11-7